Power Commander 6 Fuel and Ignition Controller // 2012-2016 Wildcat / Wildcat X

The Power Commander 6

The Power Commander 6 fuel injection tuning device allows you to optimize your fuel and timing curve (where applicable) giving you the confidence to roam freely.  With fine tune adjustability and multiple inputs, the Power Commander 6 will keep your vehicle running at its full potential letting you concentrate on the journey ahead.

Featuring a plug-and-play setup, Power Commander 6 can be installed discreetly underneath your seat, cowl, dash or other location ensuring your ride looks as good as it runs. Removing the device reverts your vehicle completely back to stock.  With the ability to store and switch between two maps on-the-fly  (via the map switch accessory) and connect to various Power Commander accessories such as the Autotune, Quickshifter or POD-300, the Power Commander 6 gives you features and functions that provide you with the ultimate ride.

Power Commander 6 Product Introduction

The New Power Commander 6 is loaded with tons of new features. 

• Compact design for discrete placement & easy uninstallation to revert to stock settings
• Easily change & upgrade tunes as you upgrade parts
• Comes with Power Core software that connects dyno runs with our EFI Tuning Devices to unlock your ride’s potential
• Pair with other Power Commander accessories like the Autotune, Quickshifter or POD-300
• Analog input allows you to install any 0-5 volt sensor and build an adjustment table based on its input such as boost or temperature
• Easily connects to your computer via USB
• Each cylinder can be mapped individually and for each gear, giving riders more granular control
• One year warranty
• Proudly made in the USA

Power Commander 6 w/ Built in Ignition Control

On select models, gain control over fuel delivery AND timing with the new Power Commander 6 with fuel and ignition control. The best of both worlds, now you can realize all the benefits of the Power Commander 6 and the Ignition Module 5 wrapped in a single enclosure. This Power Commander 6 is available for select twin cylinder engines.

• Retains all of the standard Power Commander 6 fuel control features
• Allows +/- 20 degrees of timing adjustment
• Map Switch Input – change maps on the fly
• Adjust timing per cylinder
• Raise your Rev Limit (only available on select models)
• Built In Launch Limiter

Power Commander 6 - PTi

On select models a new version of PC6 is now available that’s perfect for forced induction applications. This new unit, PCV-PTi, comes with a Bosch 3 bar MAP/Temp sensor as part of the PC6 harness for expanded capabilities built into the control center software.

The PTi version of the PC6 gives you the ability to modify your fuel curve based off a pressure (boost) table and/or temperature table. The pressure table gives you 3D mapping capability based on boost vs RPM, while the temperature table gives you 2D mapping capability with up to 50 points of adjustment.

This new version of the Power Commander 6 is perfect for turbocharged or supercharged applications looking for precision, control, and reliability.